Futaba 9C Super 2.4G 9ch Transmitter & R608FS Receiver (8ch) Combo w/ 2 Batteries

More than any other radio, the 9C Super addresses the particular needs of glider pilots, with significant upgrades that make it the finest sailplane system you can buy. And with more memory, more functions AND more flexibility for controlling all types of R/C aircraft the 9C Super is the complete radio package for the advanced aeromodeler!

Maximum 18 Model Memory
• Memory has been expanded to 12 models, and the optional 16K CAMPac module adds another six models — bringing the total up to 18.

A three-function timer, all on one screen
• Can be utilized as an up timer or down timer to keep track of total flying time (hours/minutes) for a particular model — and can be programmed to any of the switches, the power switch or the throttle stick.

One transmitter for all three modes
• The 9C Super offers you the functions and programs for airplanes, helis and gliders — all in one convenient controller.

Glider Mode
• In addition to the Basic offset trim, the 9C Super offers three other offsets (launch, thermal and speed), with camber that can be customized for each.
• The four camber mixes can be set up on one screen and programmed to any of the variable dials.
• Besides setup ease, the glider mode boasts much more built-in flexibility.
• A new G2F-C mix has been added to the G1FLP and G2FLP mixes.

Airplane Mode
• The Air Brake is now switch-selectable.
• The gyro system can be set up for 2-rate (up/down) or 3-rate (up/center/down) with the GYA gyros. It can also be programmed to any switch for normal or AVCS modes.
• Both the Airplane and Glider Modes feature 7 programmable mixes: 5 linear mixes and two 5-point curves.

Helicopter Mode
• 5-point Throttle Curve and Pitch Curve now feature a delay that makes for a smoother transition from hover to idle-up and better control.
• The throttle hold and idle-up can be assigned to any switch that feels more comfortable for the pilot.
• Hi/Low Pitch can be utilized to adjust the curves on the high side and low side for each flight condition.
• Choose from six heli mixes: SWH1, SWH2, SR3, SN3, SWH4 and the new SWH3, along with two linear circuits and one 5-point curve.

Transmitter T9C Super:
• Operating System: 2-Stick, 9-channel, PCM1024
• Modulation: 2.4Ghz (default) / FM(PPM) or PCM Switchable
• Power supply: 9.6 volts, NT8S700B included
• Current Drain: 280m
• Length: 2.56: (65mm)
• Width: 1.42" (36mm)
• Height: 0.85" (21.5mm)
• Weight: 1.42 oz (40.3g)

Standard Wall Charger:
• Input: 220V AC 50Hz 7W (default)
• Or input: 120V AC 60Hz 7W (by request)
• Output: TX 9.6VDC 70mA
• RX 4.8VDC 100mA

R608FS Receiver (FUTL8952):
• Length: 1.8" (45mm)
• Height: 0.5" (12.7mm)
• Width: 0.9" (22mm)
• Power Requirement: 4.8V or 6V

COMMENTS: The 9C Super differs from the standard 9C in that the Super's glider mode offers three offsets that can be customized, launch, thermal, and speed with camber. The four camber mixes can be set up on on screen and programmed to any of the variable dials. The Airplane Mode offers a selectable switch using channels 5, 7, and 8. All can be set up as a 2-rate (up or down) or a 3-rate (up/center/down) and a gyro gain menu. The Heli Mode offers throttle and pitch curve delay for smoother transition from hover to idle-up. The throttle hold and idle up can be assigned to any switch.

• CHP or 9CAP Super Transmitter
• R608FS 8ch Receiver
• TM-8 2.4GHz RF Synthesized Module (5-pin)
• Battery Charger (230V, EU plug)
• 700mAh Transmitter Battery NT8S700B
• 1000mAh Receiver NiCD Rechargable Battery NR-4RB
• On/Off Switch Harness, FUTM4385
• NO SERVO is bundled with this combo.